Personal Locators

SUPER PASS II

DESIGNED TO MEET THE LIFE
SAFETY NEEDS OF THE FIREFIGHTER

Super PASS II is the Loudest,
Lightest, Smallest, Stand Alone
NFPA Compliant PASS.

Auto-ON ACCOUNTABILITY KEY
The Accountability Key with Super Pass II
ensures "Auto-On" activation of the PASS
device and makes the unit compliant with
the 1982 (1998 edition) of the NFPA standard
for PASS devices (see P.A.S.S. Q&A).

Motion Sensor Alarm -- After 18-23 seconds
of no motion, the unit goes into Pre-Alarm,
at 30-35 seconds, the Super Pass II goes into
full alarm. Full alarm includes: rapid pulsing of
four red LEDs, and loud (>98dBA) audio alarm
which varies in pitch for directional finding..

Manual Alarm -- Super Pass II can be in alarm
by pressing front button.

Temperature Sensing -- Super Pass II is available
with optional temperature sensing.

Certified Instrinsically Safe -- Super Pass II
meets all requirements for NFPA 1982, 1998 edition standards.

SUPER PASS II CAN BE USED WITH or WITHOUT SCBA

ACCOUNTABILITY KEY

The Next Level of Personnel Identification

An added benefit of the TPASS is the
Accountability Key.

The TPASS 3 EVACUATE, TPASS HP II
and SUPER PASS II which are Certified
Intrinsically Safe. Are designed to be
automatically activated into the Sensing
Mode or turned ON, when removed from
storage position. At this point, the unit can
be reset from the sensing mode, but cannot
be turned OFF until the Accountability Key
is replaced and both side buttons are
simultaneously pressed.

PULL-AWAY TETHER FOR AUTO-ON ACCOUNTABILITY KEY ACTIVATION FROM STORAGE POSITION

EVACUATOR COMMUNICATOR

2-Way Signaling System!

EVACUATOR COMMUNICATOR
System incorporates radio signal Transmitting and Receiving, to and
from the COMMAND BASE LCD T3 Creating a highly advanced 2 way
signaling safety system.

Transmit an Evacuate Order
Alert Firefighter to evacuate from a no win dangerous situation
Firefighter can acknowledge the evacuate signal was received.

EVACUATOR COMMUNICATOR may be put into Alarm
Manually by pressing the front button.
Certified Intrinsically Safe to UL913.

No FCC License Required. Temperature Sensing Available

Command Base LCD T3

Total Accountability System with
Two-Way Signaling Capability

The Command Base Receives, Transmits, Captures and Displays
All Alarm Signals and Continuously Monitors and Displays the
Status of Each Individual Firefighter on scene.

Alarms received are indicated by Audio Voice Alert, Bright Flashing
LEDs, the Firefighter in need of assistance name and ID
automatically go to the top position on the display.

A built-in rechargeable battery provides up to 24 hours operation
The Command Base can also be powered by either a 12 volt DC
vehicle power or AC power from 90 to 260 volts.